Magnum 5001 Leg Extension frames are finished in high gloss electrostatic powder coating.  It is baked on to provide a uniform adhesion that is durable and attractive. Standard colors are silver metallic, white, black, and cathedral gray.  The Magnum 5001 Leg Extension offers a self adjusting leg pad assures easy automatic set up and a large back pad with lumbar support adjust with gas shock.   The easy reach adjustable starting point controls range of motion allowing for users to accomodate users with limited motion.

-Frames are finished in high gloss electrostatic powder coating. It is baked on to provide a uniform adhesion that is durable and attractive. Standard colors are silver metallic, white, black, and cathedral gray.

-Two 7.5 lb drop down plates to adjust resistance in small increments.

-Large, easy to read weight identification placards can be easily viewed for efficient setup and exercise.

-Multiple ergonomic hand grips or triple pivoting handles provide superior results for users of every level of experience.

-Counter weights effectively eliminate the weight of the arms when lifting the top plate.

-Machines are fitted with ABS plastic feet protecting floor surfaces. Some feet adjust for leveling.

-Easy glide pad adjustment can be performed from the seated position by lifting the lever under the seat without bending or twisting.

-Seats, weight stack pins, range of motion controls, roller pads, and back pad adjustments are all clearly identified by yellow knobs or covers.

-To prevent accidental contact with moving parts the outside of every weight stack is fully guarded and all pulleys are covered.

-Weight stacks are moved with 7 x 19 (3/16") lubricated steel aircraft cable tensile strength rated at 4,200 lbs and coated with nylon to 1/4". Machines use positive, four bolt attachment blocks on the weight stack and machine end for infinite cable adjustment.

-Pulleys are fiberglass reinforced nylon V-groove cut, fitted with prelubricated ball bearings.

-Unique three layer pad construction uses 3/4" plywood backboards with 3/8" x 17 T-nuts. Dense thick rebound foam is glued to the plywood. They are then wrapped with a layer of perspiration proof plastic. The second layer is matting material which cushions and protects the third layer which is double stitched, superior grade, sulfide resistant Boltaflex.